Nema 17 Stepper Motor *Wrong Casing, No Connector* CLEARANCE
This motor is being sold on clearance due to a change made during production to the motor casing. Motor was assembled with a different casing than our standard Kysan 1124090. Also, these motor wires have a raw end, with no connectors (please see below links to DIY connectors/housings kits). Motors are labeled as Kysan SKU #1124090, and match all specifications other than case design and lack of connector.
This stepper motor is a strong choice for any project.
5 motors needed for Prusa Mendel.
4 needed for OG Mendel.
Holding Torque: 5.5Kg.cm
Rated Voltage: 4.2V
NO.of Phase: 2
Step Angle: 1.8° ± 5%
Resistance Per Phase: 2.8Ω± 10%
Inductance Per Phase: 4.8mH± 20%
Current Per Phase: 1.5A
Shaft: 5mm diameter w/ one flat
Insulation Class: Class B
Dielectric Strength: 100Mohm
Operation Temp Range: -20 ~ +40° C
Lead Wire: 22AWG / 750mm
4 pin 2.54mm connector
Data sheet available here. ***Please note, data sheet specs should be identical for this motor, other than casing and lack of connector.
Available DIY connectors and housings kits:
2.54mm 1x4 Connector & Housing Kit - 5 pack *Compatible with RAMPS controller*
2.54mm 1x4 Connector & Positive Latch Housing Kit - 5 pack *Compatible with RAMBo / Mini-Rambo controller*