Cart 0
Optical Endstop

UltiMachine

Optical Endstop

$ 2.50

This item is a single Optical Endstop Circuit Board. This board is based off of the Opto Endstop RRS-OE design. These limit switches can be used with Mendel & other RepRaps. Three endstops are needed for most builds.

This item is available as a DIY assembly kit, fully assembled by UltiMachine, or you can purchase a blank PCB only.

-The DIY assembly kit includes one (1) each of the following:
  • TCST2103 Switch (PTH)
  • Terminal Block 5.08mm, 3 contacts (PTH)
  • 3 pos latch connector (PTH)
  • Opto Endstop PCB w/ SMT pre-soldered

-The fully assembled circuit board will be assembled with one each of the following:

  • 3 pin positive latch connector
  • TCST2103 Switch
  • 220 ohm 0805 SMT
  • 1K ohm, 0805 SMT
  • 10K ohm, 0805 SMT
  • Green LED, 0805 SMT
  • Opto Endstop PCB


-The blank PCB will not have any components populated. You will need to source all SMT and PTH components for assembly.

 


Share this Product


More from this collection